Rhombus Tech EOMA-68 CPU Card Prototype

Do you remember Rhombus Tech AllWinner A10 EOMA-PCMCIA CPU card that targets a BOM cost of $15 US, and was announced at the end of last year? Well, after much wait, the first prototype is now available.


This CPU module is based on AllWinner A10 Cortex A8 processor, with 1GB RAM, a NAND Flash, one USB OTG port, microSD slot, HDMI, PMIC, an Ethernet PHY (at the back), an expansion header, and the EOMA-68 connector giving access to peripherals signals (SATA, Ethernet, RGB/TTL, I2C etc…). It can act as a Linux/Android stand-alone computer or be connected to a baseboard. One of the first project will be a laptop for the Chinese market.

AllWinner A10 SoC may be a little underpowered to be used in laptop compared to the latest ARM processors, but since EOMA-PCMCIA is a standard, pin-to-pin compatible modules will eventually be designed and manufactured with different/faster (ARM) processors. New modules are expected to be designed much faster than the first one which took over one year.

PCMCIA only has 68 pins, and as Barry Kauler explains, many signals from the processor won’t go through this connector, which could explain the expansion header at the bottom of the board. Other system-on-modules are usually design with standard connectors with much more pins: SO-DIMM has 200 pins, and EDM & ULP-COM standards provide MXM 3.0 connectors with 314 pins. The lack of signals carried through the 68-pin connector will most probably affect the number of supported features and/or upgradability of those EOMA CPU cards. There are, however, pros and cons for all SoM form factors, you can read more on elinux.org.